To clean a chainsaw, start by removing the spark plug and air filter cover. Then, use a wire brush to scrub away any dirt or debris from the outside of the chainsaw. Next, take off the guide bar and chain and submerge them in warm soapy water for about 10 minutes before scrubbing with a … Read more
1. Purchase the necessary cutting tools, such as a saw or an axe. 2. Place the Christmas tree on a flat and level surface outdoors, away from any flammable objects or areas with high traffic. 3. Measure where you need to cut off the bottom of the tree and make sure it fits in your … Read more
Your chainsaw may have stopped working for a variety of reasons. The most common one is that the spark plug has malfunctioned or become dirty and needs to be replaced, adjusted, or cleaned. It could also be caused by an air filter that’s clogged with debris and dust. If your chainsaw has been idle for … Read more
1. Make sure the chainsaw is powered off and unplugged from any power source before beginning. 2. Place the chain on a flat work surface with bar side facing up, then place the drive link of the chain into its groove in the bar nose sprocket. 3. Press down on both ends of the drive … Read more
There are a few potential reasons why your Stihl saw keeps stopping. The most common cause is that the spark plug has become fouled or worn out, preventing it from sparking correctly and thus not allowing the engine to start. Another issue might be that the air filter is clogged, causing an insufficient amount of … Read more
The first chainsaw was invented in the early 19th century by a German orthopedic surgeon named Bernhard Heine. It consisted of an oscillating saw blade connected to a hand crank, and it was used for cutting through bone during surgical procedures. The blades were made from thick steel and had teeth sharpened to a point. … Read more
To store a chainsaw, first clean it with an air compressor and then lubricate all of the moving parts. Next, use a rag to wipe away any dirt or debris from the exterior body of the chainsaw. Once cleaned and dried, apply protective oil to prevent rusting and corrosion. Store in a dry place away … Read more
Full chisel chains have teeth that are sharply angled, allowing them to cut through material faster and more efficiently. Semi-chisel chains have rounder teeth which make them less aggressive but also longer lasting. Full chisel chains can be used in harder woods because they can cut deeper into the wood while semi-chisel chains work better … Read more
1. Begin by ensuring the chainsaw is turned off and unplugged. 2. Use a wrench to loosen and remove the bar nuts on either side of the guide bar. 3. Carefully remove the chain from around the guide bar, noting which way it was sitting for later reference. 4. Place your new chain onto the … Read more
The most likely reason why your chainsaw chain is coming off is because it isn’t tensioned properly. The chain should be tight enough so that it doesn’t come off during operation, but loose enough to allow for the bar and sprocket to move freely. If the chain is too loose, there won’t be sufficient friction … Read more
