How to Unlock a Craftsman Miter Saw

If your Craftsman miter saw is locked, you can follow these steps to unlock it:

1. Find the locking lever on the side of the saw near the handle.

2. Use a flathead screwdriver to depress the locking lever.

3. While depressing the lever, pull back on the handle to release it from the locked position.

  • Look for the blade lock lever on your miter saw.
  • It is usually located near the front of the saw, on the side opposite of the blade.
  • Depress the blade lock lever to unlock the blade.
  • The lever may be spring-loaded, so you may need to hold it down while you move on to step 3.
  • Turn on the saw by depressing the trigger switch located above or below the handle grip.
  • Place your workpiece against the fence at a 45 degree angle and align it with the blade.
  • Slowly lower the blade onto your workpiece using both hands until it makes contact.
  • Finish lowering the blade by depressing fully the trigger switch.
How to Unlock a Craftsman Miter Saw


How Do You Lock the Blade on a Craftsman Miter Saw?

A Craftsman miter saw can be locked in two different ways, depending on the model. For most Craftsman miter saws, there is a locking lever on the side of the blade housing. To lock the blade, simply push down on the lever.

For some models, there is a knob on the back of the housing that must be turned to lock the blade in place.

How Do You Remove the Safety on a Miter Saw?

Most miter saws have a safety lever that must be engaged in order for the saw to operate. To remove the safety on a miter saw, simply push down on the level and hold it in place while you pull the trigger. The saw should now be operational.

Where is the Safety Lockout Pin on the Chopsaw?

Most chop saws will have a safety lockout pin that is located near the blade. This pin is used to prevent the blade from rotating when the saw is not in use. To find the safety lockout pin on your particular model of chop saw, consult your owner’s manual.

How Do You Unlock a Tool Shop Compound Miter Saw?

Assuming you are referring to a Dewalt compound miter saw, the process is as follows:

-Locate the bevel lock lever on the left side of the saw. This is the large black knob near the front of the saw.

-With your left hand, hold down this lever while using your right hand to rotate the blade until it locks into place at 0 degrees.

-Now that the blade is locked in place, you can release the bevel lock lever.

-The next thing you’ll want to do is unlock the rail carriage lock lever, which is located on top of the motor housing directly above where the blade exits.

Again, use your left hand to hold this down while using your right hand to pull back on the rail carriage handle until it unlocks from the motor housing.

miter saw review unboxing craftsman 10 unlock

How to Unlock Craftsman 10 Inch Miter Saw

If you have a Craftsman 10 inch miter saw that is locked, there are a few things that you can do in order to unlock it. First, check to see if there is a key that came with the saw. If so, insert the key into the lock and turn it until the lock pops open.

If you don’t have a key, look for a reset button on the back of the saw. Press and hold this button for about five seconds. This should unlock the saw.


If your Craftsman miter saw has a lock on it, you may be wondering how to unlock it. There are a few different ways to do this, depending on the model of your saw. If you have a model that has a keyed lock, you will need to use the key to unlock it.

If your saw has a push button lock, you can simply push the button to release the lock. Finally, if your saw has a lever-style lock, you will need to flip the lever up to release the lock.

Leave a Comment