Introduction
A chainsaw is a useful tool. It helps cut wood and trees. Like any tool, it needs care. The coil in a chainsaw is important. It helps start the engine. If the coil is bad, the chainsaw won’t work.
In this guide, we will show you how to check the coil. We will use simple steps. Anyone can do it.
What is a Coil?
The coil is also called an ignition coil. It makes a spark. The spark helps start the engine. Without the coil, the chainsaw cannot run. Checking the coil is important. It helps keep the chainsaw in good shape.
Credit: www.arboristsite.com
Tools You Will Need
- Screwdriver
- Wrench
- Multimeter
- Spark plug tester
- Safety gloves
These tools are easy to find. You can buy them at any hardware store.
Steps to Check a Coil
Step 1: Safety First
Wear safety gloves. Turn off the chainsaw. Make sure it is cool. Safety is very important.
Step 2: Locate The Coil
The coil is near the engine. Remove the chainsaw cover. Use a screwdriver. Keep the screws safe. You will need them later.
Step 3: Disconnect The Spark Plug
The spark plug is connected to the coil. Use a wrench. Carefully remove the spark plug wire.
Step 4: Remove The Coil
Use a screwdriver. Remove the screws holding the coil. Take out the coil carefully.
Step 5: Test The Coil
Use a multimeter. Set it to ohms. Connect the multimeter to the coil terminals. A good coil will show a reading. If there is no reading, the coil is bad.
Use a spark plug tester. Connect it to the spark plug wire. Pull the chainsaw cord. If you see a spark, the coil is good. No spark means a bad coil.
Step 6: Reinstall The Coil
If the coil is good, put it back. Use the screws you saved. Connect the spark plug wire. Put the chainsaw cover back.
Step 7: Test The Chainsaw
Turn on the chainsaw. It should start easily. If it doesn’t, check the coil again. Repeat the steps if needed.
Common Problems and Solutions
Chainsaw Won’t Start
Check the spark plug. It might be dirty. Clean it. Check the coil again.
Weak Spark
A weak spark means a weak coil. Replace the coil with a new one.
Chainsaw Stops Running
Check the fuel. Make sure there is enough. Check the coil and spark plug.
Credit: www.youtube.com
Frequently Asked Questions
What Tools Do I Need To Check A Chainsaw Coil?
You need a multimeter, spark plug wrench, and screwdriver.
How Do I Test A Chainsaw Coil With A Multimeter?
Set the multimeter to ohms. Test the coil’s resistance.
Why Is My Chainsaw Not Starting?
A faulty coil might be the reason.
How Can I Tell If My Chainsaw Coil Is Bad?
Check for no spark at the spark plug.
Conclusion
Checking the coil on a chainsaw is easy. Follow the steps. Use the right tools. Keep your chainsaw in good shape. It will last longer and work better. Stay safe and happy cutting!
Table of Contents