Matthew Jackson

To cut down a leaning tree with a chainsaw, start by using the chainsaw to make an undercut on the side of the tree that is leaning away from what you want it to fall toward. Make sure your undercut is at least one-quarter of the way through and no more than halfway through the … Read more

To start an Echo chainsaw, first make sure that the chain brake is engaged (on) before you begin. Next, check to ensure that the throttle trigger and lock-out switch are both in their off positions. Place the chainsaw on a flat surface and locate the choke lever as well as your starting switch. Move the … Read more

The size of a file for a chainsaw depends on the type and size of chain that is being used. Generally, the size of the file should match the pitch (distance between drive links) and gauge (width or thickness) of your chain. The most common sizes are 3/16”, 7/32”, 4.0mm, 5.2mm, and 5/32” files for … Read more

To start a chainsaw that won’t start, first check the fuel tank and make sure it has enough fresh gasoline. Next check the spark plug for any signs of damage or dirt build up. If necessary, clean or replace the spark plug. Also inspect the air filter and clean if needed. Make sure there is … Read more

1. Make sure you are wearing appropriate safety gear such as hearing protection, a face shield, gloves and protective chaps when felling the tree. 2. If possible, move to the side of the leaning tree opposite of its lean direction; this will make it easier to cut the tree in a controlled manner—towards its lean … Read more

To clean a chainsaw, start by removing the spark plug and air filter cover. Then, use a wire brush to scrub away any dirt or debris from the outside of the chainsaw. Next, take off the guide bar and chain and submerge them in warm soapy water for about 10 minutes before scrubbing with a … Read more

1. Purchase the necessary cutting tools, such as a saw or an axe. 2. Place the Christmas tree on a flat and level surface outdoors, away from any flammable objects or areas with high traffic. 3. Measure where you need to cut off the bottom of the tree and make sure it fits in your … Read more

1. Make sure the chainsaw is powered off and unplugged from any power source before beginning. 2. Place the chain on a flat work surface with bar side facing up, then place the drive link of the chain into its groove in the bar nose sprocket. 3. Press down on both ends of the drive … Read more

There are a few potential reasons why your Stihl saw keeps stopping. The most common cause is that the spark plug has become fouled or worn out, preventing it from sparking correctly and thus not allowing the engine to start. Another issue might be that the air filter is clogged, causing an insufficient amount of … Read more