Matthew Jackson

Removing rust from a table saw is relatively easy with the right tools and materials. First, use a wire brush to scrub away any loose rust on the surface of the saw. Then, mix some baking soda or vinegar with water until you have created a thick paste. Spread this paste over the rusty area, … Read more

To restore a cast iron table saw top, you will need: a wire brush, sandpaper (preferably 80-grit and 120-grit), mineral spirits, metal primer, spray paint or enamel paint (depending on the size of your project), and a clean cloth. Begin by using the wire brush to remove any rust spots from the surface. Then use … Read more

To avoid kickback on a table saw, make sure to adjust the blade guard and splitters as recommended by the manufacturer. Always use a push stick when sawing small pieces of wood to keep your hands far away from the blade. Be sure that all boards are firmly clamped down before cutting. Make sure that … Read more

To change the blade on a table saw without an arbor wrench, you will need a piece of cloth or towel and two adjustable wrenches. Start by unplugging your table saw from the outlet. Place the cloth or towel over the top of the blade to protect yourself from any flying debris as you loosen … Read more

1. Consider the size of your project and the space you have available for your table saw. Make sure there is plenty of room to safely use and store it, as well as enough room to make accurate cuts. 2. Research what type of table saw will be best suited for your projects needs – … Read more

1. Begin by unplugging the table saw and cleaning off any debris or dirt on its surface with a damp cloth. 2. To remove rust, use a stiff-bristled brush to scrub the surface of the cast iron table saw. If necessary, you can also apply some mild detergent or baking soda paste to further help … Read more

Cutting thin strips on a table saw requires the use of a special jig. The jig is designed with an adjustable fence that slides along the table saw’s miter gauge slot, allowing you to adjust the width of your cut. To start, place the wood firmly against your jig and adjust it so that its … Read more

To make a box joint jig for a table saw, you’ll need some basic tools such as clamps, a drill and bit set, and screws. Start by measuring the width of your table saw blade to determine how wide the jig should be. Cut two pieces of wood for the sides of the jig with … Read more

A push stick is a tool that helps to keep your hands away from the blade of a table saw. It can be made easily with some basic woodworking skills and supplies. First, cut two pieces of plywood or hardboard into small rectangles, making sure they are long enough to reach over the top of … Read more