Table saws and miter saws are two of the most popular types of power saws used in woodworking projects. Table saws have a circular blade mounted on an arbor that spins at high speeds. The table allows for precise cuts, including rip-cuts, cross-cuts, beveled cuts, rabbet cuts, dadoes and more. Miter saws feature an arm … Read more
1. To cut circles on a table saw, you need to first make sure that your saw is equipped with a throat plate and riving knife, as these will help protect the operator from kickback. 2. Next, set up the blade height on the table saw so it’s slightly higher than the thickness of your … Read more
Ripping wood is the process of cutting a board along its length. A table saw is one of the most common tools used to rip wood, but it can also be done without one. The following are some methods for ripping boards: 1. Hand Saw: Use a handsaw or back-saw to make straight cuts in … Read more
To unlock a Dewalt table saw, you will need to first ensure that the power switch is in the “off” position. Then, locate and remove the arbor lock knob from its recess on top of the motor housing. Once removed, turn it counter-clockwise until it stops turning. This should release any tension within the saw … Read more
A table saw stand is a great way to increase the versatility of your tool. Here is how to build one: 1. Start by gathering materials such as 2x4s, screws and bolts, plywood, and other lumber you may need for the frame and top surface. 2. Cut the 2x4s into pieces that will be used … Read more
To cut plywood with a table saw, start by preparing the wood. Secure it to the saw table using clamps or hold downs and make sure that the blade is parallel to the surface of your workpiece. Once you have made all necessary adjustments, turn on your saw and set the speed according to its … Read more
To use a dado blade on a table saw, start by unplugging the saw and removing the regular saw blade. Install the dado stack onto your arbor and tighten it securely with the arbor nut. Once installed, plug in your table saw again and adjust both its height and angle to create smooth cuts. Set … Read more
A table saw is a great tool for making straight, accurate cuts. For beginners, the most important thing to remember when using a table saw is safety. Wear safety glasses and hearing protection at all times while operating the machine and keep your hands away from the blade at all times. Set up the rip … Read more
Removing rust from a table saw is relatively easy with the right tools and materials. First, use a wire brush to scrub away any loose rust on the surface of the saw. Then, mix some baking soda or vinegar with water until you have created a thick paste. Spread this paste over the rusty area, … Read more
To restore a cast iron table saw top, you will need: a wire brush, sandpaper (preferably 80-grit and 120-grit), mineral spirits, metal primer, spray paint or enamel paint (depending on the size of your project), and a clean cloth. Begin by using the wire brush to remove any rust spots from the surface. Then use … Read more
